| |
Untitled Document
|
| ▶
Elimintaes the complicated procedure,
an automatic consecutive measurement can be
made without pressing the measurement button.
|
| ▶
A built-in pressure sensor makes it
possible to check the leaky condition of probe
and inside tubes as well as helps to recognize
when changing the filter. |
| ▶
A sensor, installed in a measuring
sample Cell & each section , sensors the
temperature and provides a fixed temperature.
|
| ▶
If no measurement made within 30 minutes,
it will automatically be on stand-by due to
a built-in automatic pause function. |
| ▶
Provides accurate measurement by making
automatic Zero Calibration function. |
| ▶
Easily prints out the result of the
measurement at any time due to a fixed built-in
print function. |
|
|
|
model |
GENA-200 |
GENA-400 |
| SCOPE
OF MEAUSREMENT |
●
CO: 0 - 10% Vol |
●
CO: 0 - 10% Vol |
| ●
CO: 0 - 10% Vol |
| ●
HC: 0 - 9999PPM |
●
CO2: 0 - 20% Vol |
| ●
O2: 0 - 25% Vol |
| ●
LAMBDA 0.5~2.5 |
| O2 Sensor life time |
1 year
|
| Diplay Method |
Digital
Mode |
| Calibratioin Method |
ZERO
Calibration : Auto-Calibration
SPAN Calibration : Auto-Calibration using
span gas |
| HC span gas set-up
rate |
Propane
X 0.54 |
| Response Speed |
90%
response within 10 seconds |
| Preheating Time
|
Within
1 - 3minutes |
| Pump volume |
1.5
L/min |
| Temperature |
-10°
~ 40°, Humidity : less than 90% |
| Print |
Print
out the result of measurement |
| Transimission |
1 on
line communication |
| Power |
AC 220V(200
- 240V) 50 / 60HZ , 소비 전력 : 약 50W |
| Dimensions |
250(W)
X 200(H) X 400(D) , Unit : mm |
| Weight |
14 Kg
|
|
|
|
|
|
